Change the appearance of your knife by replacing the scale fasteners. These fasteners are available in tumbled and black oxide finish.
Ships with two Spanner bits, we recommend inserting one in each side of the scales and slowly increasing pressure on the screw to loosen them.
Spanner #4- Guardian3, Guardian3.2, Guardian3.5
Spanner #6- Guardian4, Guardian4.2, Guardain4.5, Guardian5, Guardian5.5 and Guardian6
We are aware some customers use our knives in extreme work conditions, so we try to make sure the scales are secure. We torque the fasteners to 12 in.lbs; about hand tight. The fasteners have a fine thread, and some can be more difficult to remove than others. When we remove them in the shop, we insert a bit in both sides and slowly apply pressure twisting the male fastener side. The Right scale when looking down on the spine. The process is shown in one of our videos on YouTube. https://youtu.be/rTWrlYiorpc
